Pressure Washing in Winnipeg — Handy Hour

Pressure washing winnipeg homes covers a range of surfaces, each with its own technique and pressure setting:

Concrete driveways and sidewalks: Winter brings road salt, sand, and grit. Concrete also develops algae and efflorescence (white mineral deposits). High-pressure washing with a rotating surface cleaner removes all of this without streaking the way a single wand does.

Decks and fences: Wood surfaces need lower pressure to avoid raising the grain. I treat composite decking differently from pressure-treated lumber — too much pressure on composite can void the manufacturer warranty.

Vinyl and aluminum siding: These surfaces typically need a low-pressure rinse with a cleaning solution to remove mildew and algae. High pressure at close range can force water behind the panels — I work from the bottom up and at the correct standoff distance.

Patio stones and block paving: A thorough wash removes organic buildup and brightens stone significantly. If you are planning to reseal after, cleaning is the essential first step.

I do not clean roofs — that is a specialized job with safety equipment requirements beyond what I offer.

Send me photos of the surfaces you want washed — one wide shot per area is enough for most jobs. Driveways: include the full length. Siding: show the full wall elevation.

Quote factors: total surface area, surface type and condition, how badly stained the surface is, and whether pre-treatment (degreaser, algaecide) is needed.

(888) 906-0022 · Call (888) 906-0022 or email [email protected] to get started.

Winnipeg winters are hard on exterior surfaces. The freeze-thaw cycle — where temperatures swing above and below zero repeatedly through winter and early spring — opens up hairline cracks in concrete and causes paving stones to shift slightly. Sand and grit from winter road maintenance pack into every crack and corner.

Once temperatures stabilize in spring, algae and moss begin colonizing damp north-facing surfaces quickly. Left uncleaned, organic growth holds moisture against siding and wood surfaces and accelerates deterioration.

A pressure wash in May or early June starts the outdoor season with clean, dry surfaces — and it takes a fraction of the time scrubbing would.

If you are planning to stain or seal a deck this summer, pressure washing is the mandatory first step. Stain applied to a dirty deck bonds poorly and fades unevenly. The deck needs to dry for at least 48 hours after washing before stain goes on.

I can quote the wash and the stain together, or separately if you want to do the staining yourself. The deck and fence staining service covers the staining side if you want me to handle the whole job.

Other exterior services worth combining on the same visit: window cleaning and fence and deck repair.

Back to the Exterior Services hub for the full list.

If you are getting the home ready for winter maintenance, see the guide: Preparing Your Home for Winter in Winnipeg.

Not every surface is a good candidate for a pressure washer:

Old or painted brick: Mortar in older brick can be soft, and high-pressure water blasts the mortar out of the joints. If your brick exterior was built before about 1970, a low-pressure hand wash with a brush and detergent is safer.

Stained or painted wood that is already failing: If the stain or paint is peeling, pressure washing will strip more of it off — which means you are now looking at a full strip and restain rather than just a wash. I will flag that if I see it in the quote photos.

Window glass and screens: Window glass does not need pressure washing — it needs a squeegee and glass cleaner. See window cleaning. Screens are delicate and get washed by hand.

Roofs: Roof washing is a separate specialized service with specific equipment and fall-protection requirements. I do not offer roof washing.

Spring is peak season, but a fall pressure wash before winter has its own value. Mildew and algae on north-facing siding and concrete thicken through summer. Washing in September or early October removes the organic load before it freezes into the surface and is harder to remove the following spring.

A fall deck wash also preps the wood for a final coat of sealant before temperatures drop below the minimum application temperature (usually 10°C) — after which sealants do not cure properly.

If you are combining exterior maintenance in one visit, consider pairing the pressure wash with eavestrough cleaning — both need ladder work and can be done back-to-back efficiently.

Spring slots book up fast once the weather turns. Email [email protected] a photo of your driveway or deck, and I will have a quote back to you. Or use the form: Call (888) 906-0022 or email [email protected] to get started.